If all goes well the light should remain flashing for several cycles before they turn back to solid which indicates the finish of the cleaning.For additional clarification, it should be noted that the whole point of the long pause between the first pump/hiss/fart and the pump turning back on is to give the tablet/powder enough time to dissolve. Make sure you give the machine plenty of time to allow that to happen. There's a rather long pause between the hiss/fart and the pump turning back on again for another pressurization and release cycle. If this doesn't work and no one else on here has a fix it'd be time to contact the dealer/Breville about a warranty repair, assuming yours is still in effect.Īfter the first hiss and fart the lights should still be flashing. If all goes well the light should remain flashing for several cycles before they turn back to solid which indicates the finish of the cleaning. If your rubber disk does not have a hole in it very little if any discharge from the portafilter will occur.Īfter the first hiss and fart the lights should still be flashing.
![breville clean me cycle breville clean me cycle](https://images.teamaker.biz/l-m/one-touch-tea-maker-variable-temperature-kettle-v-2996107765.jpg)
If you have the rubber disk with a hole in it there will be discharge from the portafilter as well as directly into the catch basin.
![breville clean me cycle breville clean me cycle](https://www.thecoffeearound.com/wp-content/uploads/2021/06/breville-infuser-espresso-740x785-1-200x200.jpg)
At step B you should be using the double walled single shot basket.Īt step C you should be holding the 1 and 2 Shot buttons down until they are no longer flashing and are both on solid, only then should you release them.Īt step D just for yits and giggles try pushing the 1 Shot button (Press and release, do not hold.) instead of the 2 Shot button.Īt this point the 1 and 2 Shot buttons should be alternatively flashing back and forth and the machine will start running the cleaning cycle.